Atlas Copco ETV STB63-100-13-IRC-W Produktanweisungen Seite 167

ETV STB63-100-13-IRC-W
Video týkající se bezpečnosti produktu pro dotahovače matic
Zjistěte další informace o bezpečnostních funkcích dotahovačů matic
společnosti Atlas Copco a o dalších opatřeních, která musí obsluha dodržovat,
aby zajistila bezpečný provoz. Chcete-li si video prohlédnout, klepněte na
odkaz nebo nasnímejte kód QR níže:
http://www.atlascopco.com/videogallery/#detail/77f67648-30f0-4b92-
bab6-885ea6b054db
Instalace
Installation
For installation guidelines refer to POWER FOCUS manual (9836 3123 01).
The tool calibration torque is stored in non-volatile memory in the tool.
Any changes made to the tool calibration torque in the POWER FOCUS
will update the stored value in the tool.
Model
ETV STB32/33
ETV STB62/63
ETP STB32/33
Manipulace
Operating
As tightening torque increase the reaction force build up equally. Make sure
that the tool is in correct working order and that the controller is correctly
programmed to avoid unexpected behaviour from the tool,which may result in
operator injury.
ETV/ETD: Check that the tool is in the correctrunning direction by
turning the reverse ring,
• Clockwise = Tool forward.
• Anti clockwise = Tool reverse
ETP: Check that the tool is in the correct running direction by pushing the
revers switch.
The soft-start function facilitates entering the screwhead and thread.
The duration of the soft start is adjustable, see the manual for thePOWER
FOCUS/ drive unit.
The tool is equipped with four LED´s for specific tasks:
• Connection LED: Indicates connection to Power Focus
• Battery LED: Indicates battery status (flashing light for low and fixed light
for empty battery)
• Batch LED: Indicated Batch done
• Alarm LED: A failure/event is detected
CS
Battery
Li-ion 18V / 2.6Ah
Li-ion 30V / 2.6Ah
Li-ion 18V / 2.6Ah
© Atlas Copco Industrial Technique AB - 9836 894900 00
Provozní pokyny
167