Electrolux EB6GL4XSP Benutzerinformation Seite 21

12.2 Removing the shelf supports
Remove the shelf supports to clean the
appliance.
1. Turn off the appliance and wait until it is
cold.
2. Pull the front of the shelf support away
from the side wall.
3. Pull the rear end of the shelf support
away from the side wall and remove it.
1
2
4. Install the shelf supports in the opposite
sequence.
12.3 Catalysis
The cavity is coated with catalytic enamel. It
absorbs fat during catalysis.
Spots or discolouration of the catalytic
coating have no effect on the cleaning.
1. Make sure the appliance is cold.
2. Remove all accessories and removable
shelf supports.
3. Clean the oven floor and the inner door
glass with warm water, soft cloth and mild
detergent.
4. Turn on the appliance.
5. Set function: Catalysis and press
The duration of the cleaning is fixed. You can
delay the start of the cleaning with the
function: End Time.
6. When the cleaning ends the signal
sounds. The appliance turns off. Press
any symbol to turn off the signal.
7. When the appliance is cold, clean the
oven floor with a wet soft cloth.
12.4 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
1. Fully open the door.
2. Press the clamping levers
door hinges.
A
3. Close the oven door to the first opening
position (at approximate angle: 70°).
4. Hold the door with one hand on each side
and pull it away from the oven at an
upwards angle.
5. Put the door with the outer side down on
a soft cloth on a stable surface.
6. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
2
B
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
on the two
A
on the top edge of
1
ENGLISH 21