cecotec DRUMFIT WAYHOME 1600 Bedienungsanleitung Seite 65

Checking the lubrication status of the treadmill
Lift one side of the belt and touch the surface of the board. If the surface is slippery to the
touch, no further lubrication is required. If the surface is dry to the touch, apply a small amount
of lubricant.
Applying the lubricant Fig. 17
- Lift one of the sides of the band.
- Apply a little lubricant under the surface of the board. Make sure that the lubricant reaches
the centre of the platform.
- Run the treadmill at low speed for 3-5 minutes to distribute the lubricant evenly.
ATTENTION: DO NOT over-lubricate the platform. Wipe off any excess lubricant from under
the belt.
7. TROUBLESHOOTING
Problem
The treadmill does
not switch on
The belt is slippery
The band brakes
when stepped on
The belt is not
centred
Possible causes
The machine is not plugged in.
The safety key is not properly
fitted.
The circuit breakers in the house's
electrical panel have tripped.
The main switch of the treadmill
has tripped.
The belt is not sufficiently
tensioned.
The belt is not sufficiently
lubricated.
The belt is too tight.
Belt tension is not uniform with
respect to the rear roller.
DRUMFIT WAYHOME 1600 RUNNER SPRINT
ENGLISH
Solution
Plug the power cord correctly
into a power outlet.
Put the safety key back on.
Turn the circuit breakers back
up or call an electrician to
replace the electrical panel.
Wait 5 minutes and try to
start the treadmill again.
Adjust the belt tension.
Lubricate the belt.
Adjust the belt tension.
Centre the belt.
65