Operation - Unold Kolonial 86895 Bedienungsanleitung

1. Before assembling, ensure that you are assembling the appliance in a place
that is level and dry.
2. Remove all packaging materials and transport safeguards. Keep the
packaging material, such as plastic bags or Styrofoam away from small
children - danger of suffocation!
3. Check whether all needed parts are present.
4. Have the support feet (12), the wind screws (13) and the connecting rods
(14) ready.
5. Slide one of the three holders over each of support foot.
6. A connection rod (14) must be placed between each of the supporting feet
and fastened with the wing screws (13) (see illustration).
7. Slide the rubber ring (10) over the lower end of the support tube (9) and
insert the support tube into the intended opening on the frame (12). In this
process the recess on the support tube must point to the bore on the frame.
8. Fix both components in place with the locking screw (11).
9. Remove the screw from the (5) motor.
10. Fasten the lower basket cover on the motor housing; the carrying handle
on the basket cover must point upward. Align the basket cover to the four
openings on the motor. The holes provided on the cover must be aligned
precisely above the bores on the motor housing. Fix the cover in place with
the screw (5).
11. Remove the screw from the (4) impeller.
12. Fit the impeller on the axle and fix it in place with the screw (4). In this
process the impeller must not be fitted entirely over the axle but rather must
seal flush with the axle on the front. Fasten the impeller with the screw, this
must be fixed in place on the flattened side of the axle.
13. Ensure that the impeller does not touch the basket cover, before you
proceeding.
14. Connect the front basket cover to the rear basket cover, by hooking the hook
of the front basket cover into the groove on the rear basket cover, (groove
and hook are each located at the bottom on the basket covers!)
15. Fix the two basket covers in place by closing the clamps on the edge.

OPERATION

1. Ensure that the appliance is standing on a suitable, level substrate, and has
been set up so that it is safe and stable.
2. Plug the power cord into an electrical outlet.
Copyright UNOLD AG | www.unold.de
17