Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN-38
[
]
reset
Reset
Reset the Print menu to factory defaults.
NO
= do not reset.
YES
= reset
[
ASSIGN
Assignment
[
dEmMAN
Demand
If Demand is selected, the sub-menu Stable Only will display.
Set the printing criteria.
OFF
= values are printed immediately, regardless of stability.
ON
= values are printed only when the stability criteria is met.
Auto On Stable
If Auto On Stable is selected, the sub-menu Mode will display.
Set the printing mode.
Load
= prints when the displayed load is stable.
LOAD,;2r
= prints when the displayed load and zero reading are stable.
Auto On Accept
If Auto On Accept is selected and the weighing mode is Check, values will be printed when the weight is
accepted.
ON.ACep
= printing occurs each time the display is within the acceptable range and stability criteria is
met.
[
]
IntEr
Interval
If Interval is selected, the sub-menu Time will display.
IntEr
= printing occurs at the defined time interval.
The time interval can be set through the numeric keypad（i-DT61XWE）.
Settings of 1 to 50000 seconds are available. Default is 1.
Printing occurs at the defined time interval.
MT-Continuous
If MT-Continuous is selected, the print output will be in the MT-Continuous format.
mMt.Con
= printing occurs continuously.
Note: Refer to Appendix A for MT-Continuous format.
C.SUmM
Off = disabled
On = enabled
OH-Continuous
If OH-Continuous is selected, the print output will be in the OH-Continuous format.
Note: Refer to Appendix A for OH-Continuous format.
OH.Con
= printing occurs continuously.
[
]
SICS
SICS
OFF
= disable MT-SICS command
ON
= enable MT-SICS command
Note: Refer to Appendix B for SICS commands.
[
]
End
End Print
Advance to the next menu or return to the top of the current menu.
]
]
[
]
ON.StAb
[
]
ON.ACEP
[
]
mMt.Con
[
]
OH.Con
Defender 6000 Indicators
Werbung
