Recording Interval (Normal Recording Mode); Sampling Rate (Maximum Value Registration); Automatic Shutdown; Warning Sound (On / Off) - Pce Instruments Pce-Fg 20Sd Bedienungsanleitung

7.3

Recording interval (normal recording mode)

Display value: "SP-t"
1. Enter the relevant menu and use the "
value. Confirm every entry with the "ENTER" button (3-6 Fig.1). The cursor will then switch to the
next digit automatically.
Note: The entry sequence is hour / minute / second.
2. Finally, press the "SET" button (3-8 Fig.1) to save the values. The display will now switch to the
next item automatically.
7.4

Sampling rate (maximum value registration)

Display value: "HSPt"
1. Enter the sampling rate menu and use the "
change the value. Confirm the entry with the "ENTER" button (3-6 Fig.1).
Note: The minimum value is 10 ms and the maximum value is 500 ms.
2. Finally, press the "SET" button (3-8 Fig. 1) to save the values. The display will now switch to the
next menu item automatically.
7.5

Automatic shutdown

Display value: "PoFF"
1. Enter the automatic shutdown menu and use the "
choose between "yES" or "no". By selecting "yES," you turn the function on, by selecting "no",
you turn the function off.
2. Confirm and save your selection by pressing the "ENTER" button (3-6 Fig.1).
7.6

Warning sound (on / off)

Display value: "bEEP"
1. Enter the beeper menu, use the "
"yES" or "no". By pressing "yES", you turn the function on, by pressing "no" you turn the function
off.
2. Confirm and save your choice by pressing the "ENTER" button (3-6 Fig.1).
7.7

Display unit (kg / lb / N)

Display value: "unit"
1. Enter the relevant menu, use the "
"kg", "lb" or "N". Now, the maximum value of each unit is displayed.
Note: The maximum values are 20.00 kg / 44.09 lb / 196.13 N.
2. Confirm and save your choice by pressing the "ENTER" button (3-6 Fig.1).
Manual
" (3-4 Fig.1) and "
" (3-4 Fig.1) and "
" (3-4 Fig.1) and "
" (3-4 Fig.1) and " " buttons (3-7 Fig.1) to choose between
" (3-4 Fig.1) and " " buttons (3-7 Fig.1) to choose between
11
" buttons (3-7 Fig.1) to change the
" buttons (3-7 Fig.1) to
" buttons (3-7 Fig.1) to