Saeco SM8782/30 Benutzerhandbuch Seite 23

Problem
The machine seems to be
leaking.
I cannot activate the
AquaClean water filter
and the machine asks for
descaling.
Cause
The cappuccinatore and milk
tubes are not clean.
The milk tubes are clogged.
The machine uses water to rinse
the internal circuit and brew
group. This water flows through
the internal system directly into
the drip tray. This is normal.
The drip tray is too full and has
overflowed which makes it look
like the machine is leaking.
The water tank is not fully
inserted, some water is leaking
out of the water tank and air is
drawn into the machine.
The brew group is dirty/clogged.
The machine is not placed on a
horizontal surface.
The filter has not been installed or
replaced in time after the screen
showed the AquaClean reminder.
This means your machine is not
completely free of limescale
anymore.
Solution
Remove and disassemble the internal
cappuccinatore (see 'Cleaning the internal
cappuccinatore under the tap'). Rinse all
parts under the tap. For thorough
cleaning, use Philips milk circuit cleaner
and perform the Deep Milk Clean
procedure via the 'Status' and
'Hygiesteam' menu. Note that if the parts
have been cleaned in the dishwasher, they
may have become clogged by food
particles or detergent residues. A visual
check that they are not obstructed is also
recommended.
We advise you to perform the HygieSteam
program every day: 1) Press 'Status' on the
control panel. 2) Select 'HygieSteam'. 3)
Then confirm all steps on the display.
Always store the milk container without
the milk tubes in the refrigerator. Leftover
milk could accumulate inside the milk
tubes and block the flow of milk through
the tubes. Rinse the milk tubes before
storage.
Empty the drip tray every day or as soon as
the 'drip tray full' indicator pops up
through the drip tray cover (Fig. 29). Tip:
Place a cup under the dispensing spout to
collect rinsing water and reduce the
amount of water in the drip tray.
Empty the drip tray every day or as soon as
the 'drip tray full' indicator pops up
through the drip tray cover (Fig. 29).
Make sure the water tank is in the correct
position: remove it and reinsert it into the
machine as far as possible.
Rinse the brew group.
Place the machine on a horizontal surface
so that the drip tray does not overflow
and the 'drip tray full' indicator works
properly.
Descale your machine first and then install
the AquaClean water filter.
21
English