Putting Out Of Operation; Heating Instructions - Wamsler KF 198 P Bedienungsanleitungen

Before installation pull out the delivery securer off the refractory brick through the
•
furnace chamber (picture no. 6).
Open the door by raising the handle (picture no. 2)
•
If the equipment is hot, you can use insulated gloves.
Open the primary air regulator (picture no. 3).
•
Put light wood or wood scrapings onto the fire-grate. First put small pieces of wood
•
then bigger ones on it, light them and close the door again. If the wood burns quickly
and leaves sufficient glowing embers, put further fuel on it. Following that, set the
primary air regulator (picture no. 3) and the fuel separating according to the table on
page 16.
The first kindling shall be "mild", with few fuel only, so that the lacquer covering of the
fire-place can "settle".
During the first kindling odour formation is normal, ventilation in the room is needed.

1.3 Putting out of operation

Let the glowing ember burn to ashes and the fire-place get cold.
•
Empty the furnace chamber and the ash bin.
•
Close the doors and push the primary air regulator totally to the left.
•
1.4 The fireplace shall be operated only with closed furnace chamber
door.
Fire-places with closed furnace chamber have self-locking furnace chamber doors. These
shall be opened only for kindling, loading or when cleaning the furnace chamber
(otherwise problems with draught can occur at other equipment leading to the same
chimney).
A led-in secondary air channel additionally burns the combustible
components of the flue gas. This means environment friendly smoke and
soot-poor burning.
If you wish to operate your fire-place in transit season, please control the chimney-draught
beforehand, since this can be very weak by high external temperatures. To find this out,
hold a burning match in the slightly open feeding door. If the flame is not inhausted
clearly, the chimney draught is not appropriate.
To tackle this, burn wood scrapings in the fire-place or in the cleaning hole for a short
time.
The fire-grate must be cleaned before every kindling to ensure good circulation of air for
burning.
Attention! Please do not exceed the prescribed quantities of fuel in order to preserve the
environment.
17