Putting Out Of Operation; Heating Instructions - Wamsler PLUTO Bedienungsanleitung Und Aufstellanleitung

Warning! Upon the first kindling, smoke and unpleasant smell may be gener-
ated. Always ensure the proper ventilation of the room (by opening windows
and doors), and heat the fireplace at maximum rated heating performance. If
with the first heating the maximum temperature is not reached, the above-
mentioned effects may as well arise later on.
Before installation pull out the delivery securer off the refractory brick through the
•
furnace chamber (picture 6).
Open the door by raising the handle (picture 2). If the equipment is hot, you can use
insulated gloves. Adjust the primary air regulator and the fuel switch (picture 3) ac-
cording to the Table 2. Put coal lighter or wood wool onto the fire grate, followed by
wood chips. First insert small pieces of wood, and then larger ones, light them and
close the door again. When the wood burns quickly, and leaves sufficient glowing
embers, put additional fuel on the fire. Thereafter, adjust the primary air regulator and
the fuel switch according to the Table 2 („Adjustment of the burning air"). The first
kindling should be performed "finely" with little fuel only, so that the parts of the fire-
place are adapted to heat. During the first kindling, the generation of smell is normal
and absolutely undangerous.

1.3 Putting out of operation

Let the glowing ember burn to ashes and the fire-place get cold.
•
Empty the furnace chamber and the ash bin.
•
Close the doors, and shut off the primary air regulator (position I) and the fuel
•
switch (position K).

1.4 Heating instructions

The fireplace should be operated only with closed furnace chamber door. Fireplaces
belonging to type 1 have self-locking furnace chamber doors. These doors may be
opened only for kindling, loading or when cleaning the furnace chamber (otherwise
draught problems may occur with other equipment connected to the same chimney).
When opening the furnace chamber door, any incorrect handling or insufficient
draught may induce smoke. Always ensure that the furnace chamber door may
be opened only slowly, first just to a small extent, and then fully after a few sec-
onds. In addition, if you intend to put additional fuel into the fire, before the
opening of the door only there may be only ember bed in the burning space, i.e.
no flames may be visible.
Led into the burning space in correspondence with the existing conditions, the secon-
dary air provides for the follow-up burning of the combustible components of in the
burning space. This in fact means smoke and soot-poor burning, which contributes to
the protection of the environment. If you wish to commission the fireplace in a transi-
tional period, please, please first examine the chimney draught, as it can be especially
weak at high external temperatures. Towards this end, hold a burning match in the
slightly opened feeding door. If the flame is not drawn significantly by the draught,
then a so-called starting fire is to be set first. Towards this end, burn wood chips/wool
in the fireplace or the cleaning hole of the chimney. The fire grate is to be cleaned
Warning!
28