Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
ffi
WARNING!
Only connect to drinking water supply. The water filter only filters impurities in the
►
water and makes ice clean and hygienic. It cannot sterilize or destroy germs or other
harmful substances.
Too high water pressure in the hose can damage the appliance. Install a pressure
►
reducer when the water pressure in the hose exceeds 0.6 MPa.
Before connection. check whether the water is clean and clear.
►
[ i )
Notice: Water connection
Pressure of the cold water has to be 0.15-0. 6 MP a.
►
The maximum permitted length of water hose is 8 meter. Longer hoses will affect the
►
ice cubes and cold water content.
Ambient temperature has to be O °C minimum.
►
Keep the water hose away from heat sources.
►
1. Cut the pipe into two pieces with the required
length to connect the filter ( A ) with the appliance
( B l) and the water tap ( B 2) ( F ig. 10.5-1). Make sure
to get a square cut by using a sharp knife.
2. Insert pipe ( B l) approx. 12 mm deep into the
mounting fixture of the water filter ( A ) ( F ig. 10.5-2).
Take care to install the filter in the correct direction.
T he dart shows the direction of water flow.
3. Secure the pipe with a locking clip ( C ) according to
Fig. 10.5-3.
4. Repeat step 2 and 3 with the pipe ( B 2) on the other
side of the filter
5. Connect the end of pipe ( B 2) to one of the adapters
"D" or "E and F" which suits to the water main ( F ig.
10.5-4).
6. Remove the plug in the valve at the back of appliance
( F ig.10.5-5).
7 . Connect the end ofB 1 to the valve at the back of
the appliance ( F ig. 10.5-6).
8. Open the water tab to check if the system is leak
free and flush the pipe.
WARNING!
► Ensure that the connections are always firm, dry and
leak free.
Make sure the hose is never crushed, kinked, or twis
►
ted.
r�
� t., � I
10.5-1
10.5-2
10.56
35
Werbung
