OHAUS Ranger Count 3000 Serie Bedienungsanleitung Seite 6

EN-4
3.2 Menu Structure
Cal Setup
In.Cal Reset Reset
A.Cal Filter Weighing
Cal.Adj AZT Counting
Span StableRange Percent
Lin Backlight Check
End Auto Tare Totalization
Auto Off Density
End Setup Hold
End Mode
3.3 Using the Instrument
Weighing Application
1. If required, place an empty container on the pan and press Tare.
2. Add sample to the pan or container. The display shows the weight of the sample.
4. MAINTENANCE
4.1 Cleaning
WARNING: Electric Shock Hazard. Disconnect the equipment from the power supply before cleaning.
Make sure that no liquid enters the interior of the instrument.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.
The exterior surfaces of the instrument may be cleaned with a cloth dampened with water and a mild detergent.
4.2 Troubleshooting
For technical issues contact an Authorized Ohaus Service Agent. Please visit our website www.ohaus.com to locate the
Ohaus office nearest you.
5. TECHNICAL DATA
The technical data is valid under the following conditions:

Indoor use only

Altitude: Up to 2000 m

Operating temperature range: +5 ° C to +40 ° C

Specified temperature range SJX, SJX/E models: +10 ° C to +40 ° C

Specified temperature range SJXM, SJXN/E models: +10° C to +30° C

Relative humidity: 10% to 85% at 31° C, decreasing linearly to 50% at 40° C, non-condensing

Power: AC power adaptor input 100-240V 50/60 Hz and output 5V DC, or 4 AA batteries

Mains supply voltage fluctuations: up to ± 10% of the nominal voltage

Installation category II

Pollution degree: 2
Mode Unit Print
Reset Reset
g Stable
kg A.Print
ct Int
oz Content
ozt Layout
dwt End Print
lb
grn
hkt
sgt
twt
tical
tola
End Unit
.
RANGER
* *
RS232 USB Device
Reset Reset
Baud Baud
Bits/ Parity Alt.Command
Stop Bit End
Handshake
Alt.Command
End
TM
COUNT 3000 SERIES
*
Ethrnt Bluetooth
IP Adr Device ID
End MAC
End
USB Host
Export Menu
Export App
Import Menu
Import App
End