Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1-6-39. T Soft Brake Replacement
L.
2.
Remove the T soft brake spring (1).
Remove the claw (A) on the T soft brake (2) from the
mechanical deck and remove the T soft brake (2).
Note:
Hook (B)
Claw (A)
T soft brake (2)
Brake pad (C}
.
T reel
table assembly
Fig. 6-39-1
1-6-40. Drive Lever Replacement
t. Remove the top bracket. (Refer to item "1-6-1. Top
Bracket Replacement".)
. Remove the cassette holder assembly. (Refer to item
"1-6-2. Cassette Holder Assembly Replacement".)
. Remove the drive arm assembly. (Refer to item "1-6-
5, Drive Arm Assembly Replacement".)
. Remove the cam slider. (Refer to item "1-6-41. Cam
Slider Replacement".)
. Remove the Loading Drive Assembly. (Refer to item
"|-6-29. Loading Drive Assembly Replacement.")
Remove the drive lever (1).
2-32
the reverse order of removal.
Note:
« Be sure to align the phase of the cam gear (2). (Refer
to item 1-6-41. Cam Slider Replacement".)
Drive lever (1)
Outsert (B)
Hole for phase
matching
Drive lever
post
Apply grease:
|
~Apply grease
Marking (C)
Fig. 6-40-1
1-6-41. Cam Slider Replacement
1. Remove the top bracket and the cassette holder
assembly. (Refer to item "1-6-1. Top Bracket Replace-
ment and 1-6-2. Cassette Holder Assembly Replace-
ment".)
iy
. Remove the tension spring (1).
4. Move the cam slider (4) to the right and align the
projection (A) on the mechanical deck and the cutout
portion (B) on the cam slider (4).
5. Remove the claw (C) on the cam slider (4) and
remove the cam slider (4) lifting the cam slider (4)
upward.
Hook lever assembly (2)
Tension drive laver
S soft brake (3)
Cam slider (4)
\
Claw (C)
Cutout (B)
Tension spring (1)
Fig. 6-41-1
6. Apply grease on the shaded portion of a new slider for
the replacement.
7. Mount the parts in the reverse order of removal. After
inserting the cam slider, slide it to the left direction till
it stops. (Fig. 6-26-2 shows this condition.)
Note:
When mounting the cam slider (4), slide the tension
drive lever in the direction shown by the arrow
(counterclockwise).
After completion of the replacement, confirm that the
cam slider (4) can slide to left and right directions
smoothly.
2-33
Apply grease
Apply grease
( inside Claw (C) )
Cam silder top side
Apply grease.
Apply grease.
Cam slider bottom side
Fig. 6-41-2
1-6-42. Idle Centering Lever Replacement
}. Remove the cam slider. (Refer to item "!-6-41. Cam
Slider Replacement".)
2. Remove the claw on the idle centering lever (1) and
remove the idle centering lever (1) lifting it upward.
3. After replacing the idle centering lever (1), mount the
part in the reverse order of removal.
Idle centering
Jever (1)
Boss
idte arm
/ assembly
Fig. 6-42-1
Werbung
