Toshiba V-854G Serviceanleitung Seite 30

The grip lever (41 on the cassette holder assembly (1) may
assembiy (1)
Cassette nolder Grip lever (4)
N\ /
Mechanical
deck (2)
Fig. 6-2-2
4. After removing the front side bosses (5) on both left
and right sides, remove the cassette holder assembly
(1) pulling to the front side.
5. When mounting the cassette holder assembly (1),
insert the front side bosses (5) to the U shaped groove
of the drive arm (6) and the guide groove (2) on the
mechanical deck lifting the rear side of the cassette
holder assembly (1).
Front side
boss (5)
Cassette holder
assembly (1)
Fig. 6-2-3
Front side boss (5)
1-6-3. Door Open Lever Replacement
1. Release the lock lever (2) on the cassette holder
assembly (1) pressing in the direction shown by the
arrow.
Lock lever (2)
Lock lever {2}
Cassette holder assembly (1)
Fig. 6-3-1
2. Move the cassette holder assembly (1) slightly to the
rear side.
3. Remove the claws (A) and (B) on the door open lever
(3) from the mechanical deck (4).
4. Match the boss on a new door open lever (3) and the
hole (C) on the mechanical deck, and then insert the
claws (B) first and then (A) to the mechanical deck
(4).
Door open
lever (3)
Mechanical deck (4)
Hole (C)
a
Claw (A) Claw ({B)
Fig. 6-3-2
5, Remount the cassette holder assembly to the position
as it was.
(EJECT) position.
Note:
F/L drive Mark hole
slider (1)
Marking
Claw
Drive lever gear (2)
Fig. 6-4-1
1. Top Bracket Replacement".)
_ Remove the cassette holder assembly. (Refer to item
"1.6-2. Cassette Holder Assembly Replacement"™.)
. Remove the door open lever. (Refer to item 1-6-3,
Door Open Lever Replacement.")
. Remove the drive lever gear. (Refer to item "1-6-4.
Drive Lever Gear Replacement".)
Pull the REC-inhibiting lever slightly to the front side,
turn the drive arm assembly (1) to the front side and
push it in the direction shown by the arrow, Remove
the left side bogs (2) on the drive arm assembly (1)
from the cutout of the guide groove on the mechanical
deck (3).
order of removal.
Drive arm assembly (1)
>
Left side boss (2)
Drive arm assembly (1)
Fig, 6-5-1