Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1-6-31. Cam Gear Replacement
1.
te
Remove the loading drive assembly. (Refer to item "1-
6-29, Loading Drive Assembly Replacement")
Slider Replacement".)
Lever Replacement".)
. Remove the pinch roller assembly. (Refer to item "1-
6-21. Pinch Assembly Replacement".)
. Remove the cam gear.
. Apply grease on a new cam gear on the shaded portion
as shown in Fig. 6-31-1 and the shaft of the main base.
Fig. 6-31-1
. Make the S, T stider to the slot out condition.
. Push the cam lever (1) and the pin (2) (loading slider)
in the direction shown by the arrows (A) and (B).
. Mount the cam gear at the angle which the small hole
(a) on the cam gear aligns with the hole on the
mechanical deck. (Refer to Fig. 6-31-1.)
Cylinder
Cam lever (1)
Hole for cam gear
phase matching
x
Pin (2)
(Loading slider)
ACE head
assembly
/
T slider
{Slot out mode)
No. 9 guide
Fig. 6-31-2
2-28
10. Mount the parts in the reverse order of removal.
1-6-32. S Reel Table Assembly and Washer 2
Replacement
__1, Remove the top bracket and the cassette holder
assembly. (Refer to item "1-6-1. Top Bracket Replace-
ment and 1-6-2. Cassette Holder Assembly Replace-
ment'.)
2. Remove the drive arm assembly. (Refer to item "1-6-
5. Drive Arm Assembly Replacement".)
3. Remove the cam slider. (Refer to item "1-6-41. Cam
Slider Replacement".)
4. Remove the § soft brake and S main brake assembly.
(Refer to item "1-6-38. $ Soft Brake Replacement and
1-6-37.
§ Main Brake Assembly Replacement".)
6. Remove the S reel table assembly (1) pulling it out
upward.
7. Remove the washer 2 (2).
8. After cleaning the reel shaft (3) with a cleaning kit,
insert a new washer 2 (2) to the reel shaft (3) and
apply a drop of oil to the shaded portions (two
locations) on the reel shaft (3).
9. After replacing, mount the parts in the reverse order of
removal.
10. Confirm the reel torque using a torque cassette.
Note:
* The washer 2 (2) can use repeatedly.
S reel table
assembly (1)
White
Phe Washer 2 (2)
Apply oil.
Reel shaft (3)
Fig. 6-32-1
5. Remove the washer 2 (2).
T reel table
assembly (1)
Washer 2 (2)
Reel shaft (3)
Fig. 6-33-1
Note:
+ Washer 2 (2) can use repeatedly.
2-29
1-6-34. Idle Arm Assembly Replacement
(Center Gear Pulley, Idle Kick Lever,
Idle up/down Lever)
4. Remove the claw (A) on the idle kick lever (3)
moving and pulling it upward.
5. Remove the slit washer (4).
Note:
+ Stop ring (1) is impossible to use again.
shown in Fig, 6-34-2.
ed
Stop ring (1)
Idle kick
lever (3)
Center gear
pulley (2)
Slit washer (4)
Idle up/down
lever (5)
Center gear post
Apply oil.
Holding post
Werbung
