Motorola solutions IMPRES 2 Benutzerhandbuch Seite 13

Chapter 3
Charging Procedure
When and where to use: The IMPRES
system.
Procedure:
1 Plug the charger end of the power supply cord into the power receptacle located at the back of
the charger.
2 Plug the wall receptacle end of the power supply cord into the appropriate AC outlet.
A successful power-up sequence is indicated by a single Green blink on the charger indicator.
3 Insert a radio with an IMPRES battery or a stand alone IMPRES battery into the charger pocket.
a Align the radio or battery contacts with the contacts in the charger pocket.
b Press the radio or battery into the pocket to ensure complete contact between charger and
radio or battery contacts.
Figure 1: Charging Radio with Battery
™ Adaptive Charger System is a fully automated battery care
MN004263A01-AL
Charging Procedure
13