LANCOM GS-2310P Installationsanleitung Seite 27

Installation Guide LANCOM GS-2310P/GS-2326(P+)/GS-2352(P)
Chapter 5: Configuring and monitoring the LANCOM switch
What is the IP address of my LANCOM switch?
The current IP address of the LANCOM switch after being switched on
depends on the network constellation.
5.1.2 Starting the Command Line Interface over the network
If you know the device's IP address (see section above) and the LANCOM
switch is accessible from your computer via the network, the you can use the
command line interface via the network.
24
displayed in the list, including the LANCOM switch. Double-click on this
entry to start the browser automatically with the correct IP address..
Networks with DHCP server – In its factory settings, the LANCOM switch
is set for auto DHCP mode, meaning that it searches for a DHCP server to
assign it an IP address, subnet mask and gateway address. The assigned
IP address can only be determined by using the appropriate tools (e.g.
LANconfig) or via the DHCP server. If the DHCP server is a LANCOM device,
the IP address of the LANCOM switch can be read out from the DHCP
table. If this is the case, the LANCOM switch can be accessed from any
network computer that receives its IP address from the same DHCP server.
Network without a DHCP server – If no DHCP server is present in the net-
work, the LANCOM switch adopts an address which, depending on the
model, may be "172.23.56.250" or "172.23.56.251". If this is the case,
the LANCOM switch can be accessed from any network computer with its
IP address set to the address range "172.23.56.x".
To do this, start a console such as SSH or Telnet and enter the device's IP
address as the target.