LANCOM GS-2310P Installationsanleitung Seite 25

Installation Guide LANCOM GS-2310P/GS-2326(P+)/GS-2352(P)
Chapter 4: Installation
I
I
I
22
cabinets. If necessary fix the rubber pads to the underside of the device to
prevent any scratching to other equipment.
Ensure that the device has sufficient ventilation to prevent damage
from excessive heat build-up.
LAN connection – Connect the network devices to the ports of
the LANCOM switch by means of a suitable twisted-pair cable (TP
cable). The connectors automatically detect the available data transfer
speeds and the pin assignment (autosensing).
Use only standard TP cables of category CAT 5 or better with a maxi-
mum length of 100 m to ensure the best possible transfer of data.
Cross-over cables can be used thanks to the auto-sensing function.
If optical connections are to be used, additional modules are necces-
sary which can be purchased as accessories.
Supply power and switch on – Supply power to the device by means of the
IEC power cable.
Ready for operation? – After a brief self-test, the power LED
(LANCOM GS-2310P/GS-2326(P+)) or system LED (LANCOM GS-2352(P))
lights up continuously. Green ink/Act LEDs show which LAN connectors
are being used for a connection.