STIEBEL ELTRON WKMD Bedienung Und Installation Seite 7

operation | installation
safety
7 Safety
7.1 country-specific safety information
All required steps up to and including commissioning must be
carried out by a qualified contractor. During this process, these
installation instructions must be observed.
We guarantee trouble­free function and operational reliability
only if original accessories and spare parts intended for the tap
are used.
7.2 Instructions, standards and regulations
Observe all applicable national and local instructions
!
and regulations, e.g. DIN 1988 and EN 806 in
Germany.
8 Standard delivery
The standard delivery is shown in the following diagram. The
WBMD tap is shown here as an example.
9 8 7
1 Water inlet pipe
2 Hand shower with fork (WBMD)
3 Spout with perlator
4 Wall connector for cold water connection
5 Post anchor base (alternative to the wall connector)
6 Cold water handle
7 Tap body
8 Changeover control spout ­ hand shower
9 Hot water handle
www.stiebel-eltron.com
1
2
6 5 4 3
9 Installation conditions
The tap is intended for a static pressure of up to 0.6 MPa. Install
a pressure reducer upstream of the tap in the water mains if the
static pressure is higher.
10 Installation
10.1 cold water connection via tap
»
Secure the wall connectors supplied into the wall.
»
Insert the tap bodies into the wall connectors.
»
Seal off the below surface connections of the instantaneous
water heater using the plugs provided with the tap.
10.2 cold water connection via instantaneous
water heater
»
Secure the post anchor base provided to the wall.
»
Insert the tap bodies into the post anchor base.
10.3 connecting the instantaneous water heater
»
Debur the pipes if you have reduced them.
»
Insert the water inlet pipes to connect the instantaneous water
heater and the tap body.
»
Insert the pivoting spout with the shower hose and fork for the
hand shower into the tap body.
11 Commissioning
»
Disconnect the mains fuse of the instantaneous water heater.
»
Open the left tap handle.
»
Wait until the water is flowing from the spout without bubbles.
»
Reconnect the mains fuse of the instantaneous water heater.
Wkmd | WBmd| 7