Creality Ender 3 Neo Benutzerhandbuch Seite 9

Install X-axis Passive Block
Snap the brass sleeve on the left side of the X-axis timing belt into the extruder
•
back support plate.
Attach the X-axis passive block to the X-axis profile.
•
Note: Be cautious not to screw it down, ensuring the X-axis passive block can slide along
the X-axis profile.)
After looping the X-axis timing belt around the X-axis passive block, snap the
•
brass sleeve at its right end into the extruder back support plate.
Push the X-axis passive block to the right to tension the X-axis timing belt to the
•
same state as the Y-axis timing belt, then tighten the set screw on the X-axis
passive block.
Note: Push to the right and tighten the retaining screws.
Install the X-axis Kit and Adjust Tightness
Fit the X-axis kit into the Z-axis profile, aligning the V-wheels on the left and right
•
sides with the slot in the profile and ensuring the T-rod nut is aligned with the T-
rod.
Note: Adjust the eccentric spacers on the left and right if the passive blocks on both
sides cannot fit in.
Install the Top Gantry Profile and Profile Cover
Secure the top gantry profile to the upper end of the gantry using four M5×25
•
screws.
Attach the profile covers to the ends of the top gantry profile.
•
Tighten the two retaining screws on the Z-axis passive block.
•
Install the Material Rack and Barrel
Assemble the material rack and barrel.
•
Thread the two M5×8 screws through the material rack and then screw on the M5
•
T-nuts.
Note: There is no need to fully tighten it.
Finally, secure these components to the top gantry profile.
•
9