Creality Ender 3 Neo Benutzerhandbuch Seite 12

Auto Levelling
Navigate to the Info screen, then Motion, and choose Level Bed. Return to the
•
info screen afterward.
Access the Info screen, then Configuration, and select Store Settings. (Save Z-axis
•
compensation data.)
Go to the Info screen, then Print from Media, choose the desired print file, and
•
initiate the printing process.
On the Info screen, go to Configuration, then Probe Z offset. After the printing
•
starts, monitor the filament's adhesion to the glass platform and make necessary
adjustments to the Z-axis compensation value accordingly.
Wrong: The nozzle is too far away from the platform, causing poor adhesion, and the
filaments are unable to stick properly.
Right: Filaments are extruded evenly and adhere well to the platform.
Caution: The nozzle is too close to the platform, resulting in insufficient filament
extrusion and potential scraping of the platform.
Filament winding
When waiting for the temperature to rise, hang the filament over the filament
•
holder.
Press the extrusion clamp and insert the filament along the extruder hole up to
•
the nozzle. Once the temperature reaches the target value, you will observe a
flow of filament at the nozzle, indicating that the filament has been loaded.
Note: For smoother printing, cut the end of the filament.
To replace the filament
When the printer is not in operation:
Heat the nozzle to above 185°C first, wait for the filament inside the nozzle to
•
soften, then press the extrusion handle and quickly pull out the filament to
prevent it from getting stuck at the heat break.
Replace the new filament onto the rack frame and repeat the loading procedure
•
above.
12