Inhaltsverzeichnis
Werbung
o
TAPE DECK OPERATIONS
TAPE PLAYBACK
7
1. Press the TAPE 1 MONITOR switch. The indicator above the
switch lights up.
2. ey a prerecorded tape on the tape deck connected to the TAPE. 1
jacks.
a
ee
Eeue
ne
ee
3. Adjust the volume with the VOLUME control.
4. Adjust the tone with the BASS and TREBLE controls.
NOTES:
—
@ When the tape is not to be played, press the TAPE 1 MONITOR
switch again (so that the TAPE 1 indicator goes out).
@ The tape can be played. regardless of the setting of the INPUT
SELECTOR.
E
:
TAPE RECORDING
The playback sound of a program source component, such as the
turntable, tuner, or CD player; can be recorded on tape as follows.
1. Set the REC SELECTOR switch to the TUNER, CD, or PHONO
position according to the program source to be recorded.
2. When the program source to be recorded is one of the sources
selected with the INPUT SELECTOR, such as AUX 1 and AUX 2,
set the REC SELECTOR switch to SOURCE.
3. Start playing the program source.
4. Operate the tape deck to start recording on tape.
TAPE MONITORING
When a three-head tape deck is connected to the TAPE 1 jacks, the
sound recorded:on tape can be. monitored through the speakers by
pressing the TAPE 1 MONITOR switch. In this case, the tape deck
must be connected to this unit via both recording (OUT) and playback
(IN) connection-cords.
NOTE:
;
panes:
When the tape deck is a two-head system, the recorded sound cannot
be monitored even when the TAPE 1 MONITOR switch is pressed. In
this case, however, the sound of the program source being recorded
can be monitored.
DUBBING OF PRERECORDED TAPE USING REC
SELECTOR SWITCH
For dubbing from tape to tape(s), set the REC SELECTOR switch to
TAPE COPY 2 — 1.
Tapes
can
be copied
regardless of the setting of the INPUT
SELECTOR switch.
NOTES:
;
,
@ To monitor the recorded sound, press the TAPE 1 or TAPE 2
MONITOR switch.
@ The program source selected with the INPUT SELECTOR switch
can be played during dubbing.
@ No signal is output at the TAPE 1 and DAT/TAPE 2 OUT jacks
when the REC SELECTOR switch is set to OFF. There is no need to
output a signal at the TAPE 1 and DAT/TAPE 2 jacks unless when
recording it on tape(s). Therefore, it is recommended to set the REC
SELECTOR switch usually to OFF so that the signal path inside the
~ unit can be shortened and crosstalk etc., can be reduced.
@ With the SOURCE position, the signal selected with the INPUT
SELECTOR can be recorded on tape(s).
® The tape dubbing with the TAPE COPY 2 — 1 position and the tape
recording with the TUNER, CD, and PHONO positions can be
performed regardless of the INPUT SELECTOR setting.
Werbung
Inhaltsverzeichnis
