Bosch GWS Professional HEAVY DUTY 18V-10 SC Originalbetriebsanleitung Seite 31

The rated speed of the accessory must be at least
u
equal to the maximum speed marked on the power
Status indications
Battery charge indicator Meaning/cause
(user interface) (29)
Green Battery charged
Yellow Battery almost empty
Red Battery empty
Overload protection indic- Meaning/cause
ator (33)
Yellow Critical temperature has been reached (mo-
tor, electronics, battery)
Red Power tool is overheated and will switch off
Power tool status indicator Meaning/cause
(32)
Green Status OK
Yellow Critical temperature has been reached or bat-
tery is almost empty
Illuminated red Power tool is overheated or battery is empty
Flashing red Kickback shutdown, restart protection or im-
pact shutdown has been triggered
Flashing blue Power tool is connected to a mobile device or
settings are being transferred
Connectivity functions
In conjunction with the Bluetooth® Low Energy Module
GCY 30-4, the following connectivity functions are available
for the power tool:
– Registration and personalisation
– Status check, output of warning messages
– General information and settings
– Management
Read the corresponding operating instructions for informa-
tion about the Bluetooth® Low Energy Module GCY 30-4.
Practical advice
The power tool with inserted Bluetooth
u
Module GCY 30-4 is equipped with a radio interface.
Local operating restrictions, e.g. in aircraft or hospit-
als, must be observed.
Exercise caution when cutting slots in structural walls;
u
see the "Information on structural design" section.
Clamp the workpiece if it is not secure under its own
u
weight.
Do not load the power tool so heavily that it comes to a
u
stop.
Bosch Power Tools
tool. Accessories running faster than their rated speed
can break and fly apart.
If the power tool has been subjected to a heavy load,
u
continue to run it at no-load for several minutes to
cool down the accessory.
Do not use the power tool with a cut-off stand.
u
Do not touch grinding and cutting discs until they have
u
cooled down. The discs can become very hot while work-
ing.
If the power tool becomes electrostatically charged, the
built-in electronics will switch the power tool off. Press the
on/off switch (6) again to restart the power tool.
Rough grinding
Never use cutting discs for rough grinding.
u
®
Low Energy
The best rough grinding results are achieved with a set angle
of 30° to 40°. Move the power tool back and forth with mod-
erate pressure. This will ensure that the workpiece does not
become too hot or discolour and that grooves are not
formed.
Flap disc
The flap disc (accessory) enables you to machine curved
surfaces and profiles.
Flap discs have a considerably longer service life, lower
noise levels and lower sanding temperatures than conven-
tional grinding discs.
Solution
–
Replace or charge battery soon
Replace or charge battery
Solution
Run the power tool at no load and allow it to
cool down
Leave the power tool to cool down
Solution
–
Run the power tool at no load and allow it to
cool down, or replace or charge the battery
soon
Allow the power tool to cool down, or replace
or charge the battery
Turn the power tool off and on again
–
1 609 92A 6YN | (28.07.2021)
English | 31