Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11. The display shows ER2
(Fig.36.B) (type "II"/"III"
handle - Advanced
Series).
12. The display alternati-
vely shows ER2+ER3
(Fig.36.B) (type "II"/"III"
handle - Advanced
Series).
13. Mowing is difficult.
14. Excessive noise and/or
vibration is experienced
whilst working.
15. Battery power reserve
is low.
16. The battery charger is not
recharging the battery.
15. ATTACHMENTS ON REQUEST
15.1
"MULCHING" KIT
It cuts the grass cuttings finely and leaves them
on the lawn, instead of collecting them in the
grass catcher (for compatible machines).
15.2
BATTERIES
Different capacity batteries are available to
suit specific operating requirements (Fig.37.0).
The list of approved batteries for this machine
is found in the "Technical Data" table.
Cutting means blocked.
Motor anomaly.
The cutting means is not
in good condition
Cutting means fittings are loose or
the cutting means is damaged.
Severe working conditions requiring
greater current absorption.
Battery is insufficient for
operating requirements.
Battery is not correctly inserted
in the battery charger.
Unsuitable environmental conditions.
Dirty contacts.
The battery charger is not energised.
Faulty battery charger.
Turn the machine off, remove the
safety key and wear work gloves.
Check and eventually remove any obstructions
in the machine lower side (par. 7.3.2) that
prevent rotation of the cutting means.
If the problem continues, contact an
authorised Technical Assistance Centre for
checks, replacements or repairs (par. 8.1).
Remove the safety key and contact
the Technical Assistance Centre for
checks, replacements or repairs.
Contact a Technical service centre
for the sharpening or replacement
of the cutting means.
Immediately turn off the motor
and remove the safety key.
Contact an authorised Technical
Assistance Centre for checks,
replacements or repairs (par. 8.1).
Optimise operations (par. 7.2.1).
Use a second battery or extended
battery (par. 15.2).
Check it is correctly inserted (par. 7.2.3).
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual).
Clean the contacts.
Check it is plugged in and the
power socket is energised.
Replace with an original spare part.
If the problem persists, refer to the
battery/battery charger manual.
15.3
BATTERY CHARGER
Device used to recharge the battery (Fig.38.0).
EN - 14
Werbung
