Werbung
Verfügbare Sprachen
Verfügbare Sprachen
13. MAINTENANCE TABLE
Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Checking the guard and
side discharge chute
Check the cutting means
Check the battery
charge status
Recharge the battery
General cleaning
and inspection
Checking for any damage to
the machine. If necessary,
contact the authorised
service centre.
Cleaning the air filter
Cleaning the transmission
Replacing the cutting-means
Drive adjustment
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or a specialised Service Centre
*** Operation to be performed at the first signs of any malfunction
14. PROBLEM IDENTIFICATION
If problems persist after having performed the above operations, contact your dealer.
PROBLEM
1. The motor does not
start when the switch
is pressed (type "I"
handle).
2. When pressing the
power button, the di-
splay does not turn on
(type "II"/"III" handle -
Advanced Series).
Frequency
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
After each use
After each use
Once a month
1-2 times a year
-
***
PROBABLE CAUSE
Safety key is not inserted or is inserted
incorrectly.
Battery is not inserted or is
inserted incorrectly.
Low battery.
Motor start-up is slow.
The thermal protection has tripped
due to overheating of the motor.
Safety key is not inserted or is inserted
incorrectly.
Battery is not inserted or is
inserted incorrectly.
Insert the key (par. 6.3).
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.4).
Check the battery status and recharge
if necessary (par. 7.2.3).
Press and hold the control lever
for 1-3 seconds (par. 5.2).
Wait for at least 5 minutes and
then restart the machine.
Insert the key (par. 6.3).
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.4).
EN - 12
Notes
par. 7.4
par. 6.2
par. 6.2.1
par. 6.2.1
*
par. 7.2.3 *
par. 7.3
-
par. 7.6
par. 7.5
par. 8.1 ***
**
SOLUTION
Werbung
