Bosch MCM4000/01 Gebrauchsanleitung Seite 16

en Operation
After switching off, the drive continues
running for a short time. Change tools only
when the drive is at a standstill.
Caution!
The appliance can only be switched on to
process food in the bowl when the bowl is
attached and when the lid is attached and
screwed on tight.
Universal blade
for cutting, mincing, mixing and
kneading.
W Risk of injury from sharp blades!
Do not touch universal blade with
bare hands. Take hold of the universal
blade by the edge of the plastic handle only.
When not in use, always put the universal
blade back into the accessories drawer.
Whipping / beating disc
for cream, egg white and
mayonnaise.
X Fig. C
■ Attach the bowl (match arrow on bowl
to dot on appliance) and rotate as far as
possible in a clockwise direction.
■ Press the drive shaft into the tool holder
until it locks into position.
■ Insert tool holder into the bowl.
■ Place universal blade or whipping disc
into the tool holder and let go.
Caution!
Do not add ingredients until the tools have
been inserted.
■ Add ingredients.
■ Attach lid with pusher (match arrow
on lid on dot on bowl) and rotate in
a clockwise direction. Lid lug must
be located fully in the slot in the bowl
handle.
■ Plug the mains plug into the mains.
■ Set the rotary switch to the desired
setting.
■ To add more ingredients, set the rotary
switch to P.
■ Remove the pusher and add ingredients
through the feed tube.
16
Carrier disc and disc inserts
W Risk of injury from sharp blades!
Exercise particular caution when handling
disc inserts! Note shape and location of the
insert when inserting it into the carrier disc.
Take hold of carrier disc by the designated
recessed grips only.
Do not reach into the feed tube. Only use
the pusher to push down.
Slicing insert A, coarse
Turn the rotary switch to a low speed
setting. For slicing cucumbers and carrots.
Slicing insert B, fine
Turn the rotary switch to a high speed
setting. For slicing cucumbers and carrots.
Shredding insert C, coarse
Turn the rotary switch to a high speed
setting. For shredding apples, carrots and
cheese. Not suitable for very hard food, e.g.
salami.
Shredding insert D, fine
Turn the rotary switch to a high speed
setting. For shredding carrots and cheese.
X Fig. D
■ Attach the bowl (match arrow on bowl
to dot on appliance) and rotate as far as
possible in a clockwise direction.
■ Insert drive shaft into the bowl.
■ Insert the required insert into the carrier
disc. Note the shape and location of the
insert! X Fig. D-5a
■ Attach the carrier disc to the drive shaft.
■ Attach the lid with the pusher (match
arrow on lid to arrow on bowl) and rotate
in a clockwise direction. Lid lug must
be located fully in the slot in the bowl
handle.
■ Plug the mains plug into the mains.
■ Set the rotary switch to the desired
setting.
■ Fill with contents which are to be sliced
or shredded.
■ When pushing down ingredients for
slicing or shredding, apply only light
pressure to the pusher. Remove the
pusher and add ingredients through the
feed tube.