3M Peltor WS Lite-Com Bedienungsanleitung Seite 10

FACTORY DEFAULT (Reset)
To reset this headset to the factory default values, press the UP (+) and DOWN (–) buttons at the same time and then press
the ON/OFF/MODE (Θ) button as well. A voice message "factory defaults, no paired devices" will follow. Start using the
headset without Bluetooth or turn off the unit by pressing ON/OFF/MODE (Θ) button again. Factory default reset is only
accessible from OFF mode.
Factory default settings; see above "QUICK GUIDE".
IMPORTANT USER INFORMATION
The headset must be worn, adjusted, cleaned and maintained in accordance with this manual. As with any hearing
protector, incorrect use or failure to follow the instructions supplied with this product could result in permanent disability due
to exposure to noise.
NOTICE! 100% use of a proper hearing protector is the only certain protection from hearing loss.
In environments with more than 82 dB A-weighted noise level, you need to protect your hearing. The hearing receptors in
your inner-ears may be irreparably damaged if you lift a cup of your hearing protectors for even a very short time in a noisy
environment.
The use of a comfortable hearing protector, designed for the specific noise level in which it is used, is the best guarantee to
that you will wear the hearing protector 100% of the time to protect yourself from permanent hearing loss.
For best protection, brush aside excess hair around your ears so the cushions fit snugly on your head. The arms/bands of
any spectacles or goggles worn should be as thin as possible to allow the hearing protector to fit closely to the head.
MAINTENANCE / CLEANING
After prolonged use, or other situations in which the headset attracts moisture inside the cups, remove the cushions and
inserts to allow the hearing protector to dry before its next use.
Do not store the headset in temperatures exceeding +55°C, for example on a car dashboard/hat shelf or window sill.
The headset (especially the ear cushions) can eventually wear out. Inspect regularly for signs of any physical damage and
replace if necessary. Certain chemical substances may be harmful to this product. Contact 3M for more information.
Clean/disinfect the shells, headband and ear cushions regularly with soap and warm water. Notice! Do not immerse in
water or fluids.
This product is covered by the WEEE directive 2002/96/EC and is recyclable. Dispose of the product in accordance with
national regulation. Use a local recycling system for electronic products.
BATTERIES (C)
When the low battery warning alarm sounds, the unit switches off automatically after a few minutes.
The NiMH rechargeable battery Peltor ACK051 should be charged with a Peltor FR05 charger only. One unit of each is
included in the delivery.
Other type AA batteries can also be used; both accumulator batteries and 1.5 V alkaline batteries. Install the batteries in the
battery lid.
Before closing the lid, make sure that the + and – poles of the batteries are in the correct position! (see the figure in the lid).
Never replace or install batteries with the unit switched on. Before switching on again, make sure that the batteries are
inserted correctly.
WARNING! If you use rechargeable batteries, charge them in accordance with the manufacturer's instructions only. Dry cell
batteries can explode if charged!
8