Mounting The Device; Turning On And Off - Peiying PY-DVR032 Bedienungsanleitung

4
4
7

Mounting the device

Dashcam:
1. The device has to be installed on cars rear view mirror.
2. Place the device in a way that the camera is next to the cars original
EN
rear view mirror.
3. To secure the device in place, put provided rubber restraints on the
hooks.
4. Plug one end of the car charger into the USB-C socket in the dashcam,
plug another end into the vehicle's cigarette lighter socket.
5. Adjust the mirror according to drivers position. Point of view of the
camera can be adjusted by moving the camera in its socket.
Note: Place the cable in a way, that it does not disturb the driver while
driving.
10
Owner's manual
1 2 3
4
5
4
6
R 9
Rear camera:
Before installation, choose the correct place for mounting. Mounting
place has to be installed in a way, that it does not obstruct field of view.
Rear camera can be installed in two ways:
• On mounting tape. Peel off first piece of paper from the tape and stick
it to the camera's mounting bracket. Peel off second piece of paper
from the tape and stick the camera do selected place.
• On screws. Drill the holes in selected place and screw in the camera.
During drilling make sure, that no damage is done to any wire,
especially for safety systems.
After connecting the 2,5 mm plug to the AV socket in the dashcam, the
view from rear camera will appear on the display. If red wire will be
connected to the reversing lights (for example with quick connector),
after shifting into reverse gear, the view from rear camera will be
enlarged, helping the driver with maneuvering the vehicle. Note: for this
function to work, the red wire has to be connected to the same electrical
installation.
8
MicroSD card installation
1. Place the microSD card in the proper slot of the device and press
gently, until it clicks. Make sure, that the card is installed in correct
way.
2. To take out the card, press it gently. When the card slides out of the
slot, take it out.
Notes:
• The microSD card in the device will be treated as storage device. It is
advised to format it first.
• Use microSD cards with class 10 or higher, with maximum capacity of
256 GB.

Turning on and off

1. To turn on the device:
• Press and hold the power button
• If the dashcam is connected to the cigarette lighter socket, the camera
will turn on automatically after ignition and start recording.
2. To turn off the device:
• Press and hold the power button
• If the camera is connected to the cigarette lighter socket, after turning
off the engine, the dashcam will turn off after 5 seconds.
3. Press the power button to turn on or off the display.
Owner's manual
EN
11