SOMFY Sonesse 30 RS485 Anleitung Seite 6

EN
▪ This can be achieved by fastening the tube to the wheel using self-tapping
screws, or steel pop rivets, placed between 5 mm and 15 mm from the outer
edge of the wheel, regardless of the tube.
▪ or by using a wheel lock, for non-smooth tubes.
CAUTION
The screws or pop rivets must only be fastened on the wheel and not on the
drive.
2.1.5.Installing the drive-tube assembly
CAUTION
• The motorised product must not be compressed between the brackets.
• Do not use the plastic cross without the metal bracket adapter.
▪ The drive can be fixed directly onto the drive bracket (the screw holes are
spaced 29 mm apart). Use 2 screws (3.5 x 9 mm). A manual tightening torque of
1 Nm is recommended.
▪ Drive plates are also available in the current
catalogue (Select the correct drive plate
adapted to the bracket and check the
torque requirements in the system). Use
the 2 screws (3 x 6 mm) delivered with the
motor plate. A manual tightening torque of
0,3 Nm is recommended.
1] Screw the bracket adapter to the drive
head.
2] Install and fix the drive-tube assembly
onto the end bracket (c) and onto the
drive bracket (d).
6
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
Sonesse 30 RS485
d
c