SOMFY Sonesse 30 RS485 Anleitung Seite 5

Sonesse 30 RS485
1] Unclip the cover.
2] Clip the new cover on the head.
2.1.2.Preparing the drive
CAUTION
• Sonesse 30 RS485 : interior diameter of the tube has to be Ø27.7 mm or
greater.
• The crown is mandatory.
1] Fit the accessories required to integrate
the drive into the tube:
ð Fit the crown (a) and the wheel (b) to
the drive.
2] Measure the length (L) between the inner
edge of the drive head and the rim of the
wheel.
2.1.3.Preparing the tube
1] Cut the tube to the required length.
2] Deburr the tube and remove the debris.
2.1.4.Assembling the drive-tube
1] Slide the drive into the tube. For tubes
with a smooth interior, position the cut
notch on the crown.
2] The wheel must be locked in place to
prevent any movement in the tube.
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
1]
2]
1] 2]
1]
2]
EN
a
b
5