HP OneShred Auto 80CC Bedienungsanleitung Seite 14

EN
11 Automatic infeed (open)
12 Access pins for the top access panel 1
13 Access pins for the top access panel 2
Small pieces of shredded paper could get into the interior of the shredder and waste bin. This
is normal. All HP shredders are tested at the factory to ensure the required the quality.
Positioning the Shredder and Starting It Up
The shredder only operates when the waste bin supplied is fitted. Do not position the shredder
near any sources of heat and maintain a distance of at least 10 cm to walls. This ensures the
shredder is sufficiently cooled.
1
Set the shredder down on a stable, level, horizontal surface and in the vicinity of an easily
accessible power socket.
2
Slide the waste bin in the device. The waste bin latches audibly in place with a click. If the
waste bin is not fitted in the device properly, the shredder cannot be switched on.
Only use the power cable supplied.
3
Connect the power plug to a power socket.
4
Switch the device on by sliding the On/Off sliding switch to the "On" position.
Î The "Ready" status LED lights up blue.
Î You have put the shredder into operation.
Operating the Shredder
The shredder works using an automatic shredding mechanism. The shredder is operated using
the operating buttons on the top of the device.
Observe the maximum permissible cutting capacity and other specifications defined in Section
Technical Data.
Warning!
This device is not intended to be used by children. Prevent hands, clothes and hair coming
into contact with the insertion slot. Unplug the power plug if the device will not be used for
a longer period. This device is equipped with hazardous moving parts, so ensure you keep
limbs well away from the moving parts.
14 Power cable
15 Waste bin
16 Viewing window
- 14 -