HP OneShred Auto 80CC Bedienungsanleitung Seite 18

EN
Major Paper Jam in the Manual Infeed
1
Switch the device off by sliding the On/Off sliding switch to the "Off" position.
2
Disconnect the power plug from the power socket.
3
Wait at least 40 minutes until the thermal overload protection has reset.
4
Connect the power plug to a power socket.
5
Switch the device on by sliding the On/Off sliding switch to the "On" position.
6
Slide the On/Off sliding switch to the "Rev" position.
7
Pull the material out of the shredder.
Î You have cleared the paper jam.
8
Slide the On/Off sliding switch to the "On" position.
Î You have put the shredder into operation.
Oiling the Cutting Mechanism
If you want to increase the working life of the shredder, you should oil the shredder's cutting
mechanism at regular intervals.
Special oil and oiled sheets are available for the shredder from HP.
Important!
Risk of property damage through using the wrong oil! Do not use spray oils. Only use a special oil
intended for shredders.
There are various ways to oil the cutting mechanism.
Oiling Using Self-Oiled Paper:
1
Apply the special oil for shredders in several lines horizontally across a sheet of paper.
2
Insert the oiled sheet of paper in the insertion slot.
Î The paper with oil applied is inserted and oils the cutting mechanism.
Oiling Using Oiled Sheets
1
Insert the oiled sheet in the paper infeed.
Î The paper with oil applied is inserted and oils the cutting mechanism.
- 18 -