Philips 7000 Serie Bedienungsanleitung Seite 31

Problem
The LEDs in the nozzle do
not come on.
The LEDs in the handheld do
not come on.
The light in the accessory
does not come on.
The lighting in my nozzle,
handheld, and accessories is
not bright enough.
The appliance is not
charging.
Possible cause
(code i4) The brush may stop
turning when it encounters too
much resistance from a high-
pile carpet.
The roller brush has not been
assembled properly into the
nozzle after cleaning.
(code: E9) The motorized
nozzle is overheated.
The nozzle has not been
attached to the tube or
appliance properly.
The lighting feature is disabled. Enable this feature in the menu. Adjust the
The lighting feature is disabled. Enable this feature in the menu. Adjust the
The accessory is attached to the
tube.
The accessory is not attached to
the appliance properly.
The brightness is dimmed.
The power plug is not
connected properly to the
appliance or the adapter is not
inserted into the wall socket
properly.
The power plug is not placed
properly in the charging
station.
(code i7) An adapter other than
the supplied adapter is being
used.
(code i10) The battery is not
properly installed.
Solution
Switch off the appliance and then switch it
back on again.
Follow the instructions in the cleaning
chapter of the user manual to slide the
roller brush into the nozzle properly. Secure
the roller brush inside the nozzle by
snapping the locking lever in place.
Switch off the appliance and wait 15
minutes. Touch the upper housing of the
nozzle to feel if it is still warm. If the nozzle
is still warm, wait longer for the nozzle to
cool down. Once the nozzle has cooled
down, try switching the appliance back on.
Attach the nozzle to the appliance or
handheld properly.
brightness of nozzle LEDs in the menu.
brightness of handheld LEDs in the menu.
Remove the tube and attach the accessory
directly to the handheld.
Attach the accessory to the appliance
properly.
Adjust the brightness of lighting in the
menu.
Make sure that the power plug is
connected properly to the appliance and
that the adapter is inserted into the wall
socket properly.
Make sure the plug is fixed properly in the
charging station. Check if the plug is angled
and the charging station is holding the
plug in place.
Make sure that you use the adapter
supplied.
Make sure that the battery is pushed all the
way in the slot and properly installed.
English
33