Strands S 25 T Bedienungsanleitung Seite 13

MODEL S 25 T
Cleaning:
All bright parts of the machine are treated with rust prevention. By removing this, be
careful not to use too strong cleaning compound. The paint might then get damaged.
Installation:
The machine must be installed on a firm foundation. The base plate must be levelled
with washers on the foundation bolts, to prevent harmful stresses when the nuts are
tightened.
Lubrication:
All high-speed shafts and gears are journalled in ball bearings or roller bearings, so
that the machine needs very little lubrication.
THE GEAR HOUSING MUST NOT BE FILLED WITH OIL.
EXCESSIVE LUBRICATION SHOULD BE AVOIDED, AS EXCESS OIL CAN
DROP INTO THE MOTOR AND DAMAGE ITS INSULATION.
Connections to mains:
The connection to be effected direct to the thermal overload circuit breaker or on
multispindle machines to a junction box common for all drilling heads.
Note the earth screw!
(see attached wiring diagram.)
Spindle speed selection:
The selection of the different spindle speeds according to the plate on the front of the
drive gear box is effected by the levers on the left hand side of the gear box and also
by means of the pole change switch for the motor.
General:
IT SHOULD BE NORMAL PRACTICE TO DISCONNECT THE MACHINE FROM
THE MAINS BEFORE ANY DISMANTLING TAKES PLACE. ON RE-
ASSEMBLY, SEE TO IT THAT ALL SURFACES ARE CLEAN AND THAT ANY
BURRS, WHICH MAY HAVE BEEN MADE DURING DISASSEMBLY, ARE
FIRST REMOVED.
13