eta emily Bedienungsanleitung Seite 15

B control panel
–
*
B1 – ON/OFF button
B2 – temperature settings button
B3 – display (current/set temperature)
C removable stand
–
C1 – center connector
* The control electronics ensures the appliance turns off automatically after the set temperature
or boil of water has been reached.
III. INSTRUCTIONS FOR USE
Fill the kettle with clean cold water up to max., turn it on and let the water boil before first use.
Then Pour the water out and repeat the process several times (at least five times).
USE
Unwind the necessary length of the power cord C2 from the storage space of the stand C.
Insert the plug of the power supply into the electrical outlet plugs. Open the lid A3 by pressing
the lock button A4 and fill the kettle with drinking water. The minimum and maximum amount of
water is marked on the watermark A2. Then close the lid by snapping. Place the filled kettle on
the stand (an audible signal sounds and the B3 display shows the current water temperature).
A) Water heating to 100°C
Press the B1 button to switch on the heating (the display flashes the number 100 twice and the
B4 light lights up). When the water reaches the boiling point, the heating is switched off (the
beep sounds 2 times) and the kettle switches to standby mode. The display shows the current
water temperature. After 20 minutes of inactivity, the kettle switches off automatically (the display
goes out).
B) Water heating to a temperature of 40 - 90°C + KEEP WARM functions
Press button B2 to select the desired heating temperature (in the following sequence: 40-50-60-
70-80-90 °C). The selected value will be shown on display B3, the current water temperature
will flash twice then the current water temperature will remain lit and the indicator light B5 will
light up). When the set water temperature is reached, the temperature maintenance function will
be activated automatically (indicator light B5 will be permanently lit). This function will be active
for approx. 2 hours. After this, the beep will sound 2 times, the B5 light will go off and the kettle
will switch to standby and after another 20 minutes, the kettle will automatically switch off (the
display will go off).
Always use fresh drinking water for boiling. The temperature and time heating depends on the
amount of water and the initial temperature of water. For the correct temperature setting, follow
the manufacturers' instructions that are described on food packages (e.g. tea, coffee, instant
drinks, soaps, etc.).
• 40 °C = infant formula milk,
• 50 °C = baby foods,
• 60 °C = hot beverages,
• 70 °C = green tea,
• 80 °C = white teas,
• 90 °C = oolong teas, coffee, instant drinks, soups,
• 100 °C = black, herbal teas.
B4 – temperature function
B5 – KEEP WARM function
C2 – power supply
EN - 15
EN