Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Disconnect the installation from power before mounting.
Select a plane mounting surface. The bottom of the module
must lie flat on the mounting surface.
1. Screw the lower part onto the mounting surface (mounting holes
mounting screws not supplied).
2. Insert the AS-i standard cable (yellow) and the cable for external
power supply (black). Ensure correct positioning of the cable in the
profiled slot.
3. Put the upper part on the lower part and tighten the screws
(screws supplied).
4. Screw the upper part onto the mounting surface (mounting hole
mounting screw not supplied).
If the module is used at the end of the cable line, the ends of the two
flat cables should be secured by means of shrink wraps (order no.
E70113).
Cover the sockets not used with the enclosed protective caps to
guarantee the protection rating IP67.
If required, you can ground the module via the earth springs (1*).
lower part with profiled
slots for flat cable
1* earth springs
AS-i
fixture infrared adapter
1
,
2
3
,
7
PAGE
Werbung
