Akrapovic Slip-On Line Einbauanleitung Seite 15

6. Position the muffler correctly and slide it onto the stock exhaust outlet, hand tight the muffler's bracket (using bolt
and washer from Akrapovič installation kit) onto the sub frame. Reinstall the servo motor in the reverse order from
the order in which it was removed. Check motorcycle manufacturer manual for correct tightening torques (F 19).
IMPORTANT: be careful not to damage the exhaust or any other part of the motorcycle during this process!
IMPORTANT: do not fully tighten the bracket bolt yet!
7. Screw the heat shield's bolts and heat-resistant washers from Akrapovič installation kit on Akrapovič heat shield, bare
in mind that the bolt that screws into the stock bracket is an M6; tighten the bolts to the specified torques (F 20).
IMPORTANT: make sure to place the heat resistant washers between the brackets and carbon fiber heat
shield and between bolts' heads and heat shield!
INSTALLATION TIP: screw the heat resistant washers onto the bolts; do not try to push them on!
15 / 20
M6
4.9Nm
3.6ftlb
M5
F 19
9.8Nm
7 ftlb
M6
F 20