Akrapovic Slip-On Line Einbauanleitung Seite 14

www.akrapovic.com
4. Correctly attach the cables onto the exhaust valve and tighten the cable elbow nuts to the specified torque. During
tightening of nuts, make sure that the cable retainers sit tight at the marked points of the valve housing (F 17).
IMPORTANT: after tightening of nuts, the cable retainers should sit tight at the marked points of the valve
housing!
CAUTION: be careful not to injure yourself or damage any part of the exhaust during this procedure!
5. Install the Akrapovič carbon fiber valve cover using bolts and heat resistant washers from Akrapovič installation kit
tighten the covers M5 bolts to the specified torque (F 18).
IMPORTANT: make sure to place the heat resistant washers between the brackets and carbon fiber valve
cover and between bolts' heads and carbon fiber valve cover!
INSTALLATION TIP: screw the heat resistant washers onto the bolts; do not try to push them on!
9.8Nm
7 ftlb
4.9Nm
3.6ftlb
F 17
F 18
14 / 20