Werbung
Troubleshooting Guide
@ Check out the following points before calling in the service-
Contact your dealer if the remedies listed below do not
man.
correct the trouble.
Platter does not rotate.
Power cord plug is disconnected.
Connect the plug to the power outlet.
Power
switch
is at
OFF
(released
Set the power switch to ON (depressed
position).
position).
No sound.
Output leads disconnected.
Connect
them
to
the
amplifier's
PHONO jacks.
Incorrect amplifier operation.
Operate
correctly with reference
to
Owner's Guide.
Improper connection of output leads.
Connect output leads properly.
Ground wire is not connected.
Connect
ground
wire to amplifier's
GND terminal.
Tempo of sound is odd.
Selected SPEED selector switch position
Set SPEED switch in line with rated
does
not
tally with
rated
speed
of
speed of record.
record.
Platter
speed has not been
adjusted
Adjust properly.
properly.
Sound is distorted.
Dirty stylus.
Clean stylus.
Lots of noise.
Warped or scratched record.
Replace record.
Amplifier's tone controls are set too
Turn down tone controls.
high.
Turntable not installed horizontally.
Install horizontally.
Tone arm malfunction in auto-
Record used is any color (like white,
These operations do not indicate that
matic play mode.
red) other than black; record does not
anything is wrong with the turntable.
* Tone arm does not descend
conform
to official standards;
non-
Set the turntable to manual play mode.
even
if START
(program
recorded sound grooves between tracks
* Use
a different
record
and when
sel) switch is depressed.
even on black records are extremely
playing it, select the sensor sensitivi-
Tone arm does not descend
narrow;
high signal levels on record;
ty selector switch.
on track selected by START
or record
with rough sound groove
(program sel) switch.
pitches.
Turntable exposed to direct sunlight or
Change installation location.
Ee
ee
Tone arm does not return to
Ground wire is not connected.
Connect
ground
wire
to amplifier's
arm rest.
GND terminal.
Tone arm does not descend in
automatic
play mode ("f7"
Stylus cover is set to down position.
Raise cover.
is indicated).
33
Werbung
