Force A-Serie Bedienungsanleitung Und Teileliste Seite 3

Sanders may coast for a short time after the trigger is released.
Be sure tool has come to a complete stop before setting it aside.
Sanders that do not come to a complete stop before setting aside can cause injury.
Backing pads that are worn, damaged, nicked, bent, warped or burred can cause the sanding disc to tear and burst.
Do not use backing pads that are worn, damaged, nicked, bent, warped or burred.
Sanding pads that burst can cause injury.
Modifications to the sander can effect tool performance and safety.
Do not modify the sander. Do not operate the sander if it has been modified or damaged. Periodically inspect sander for damage
and to ensure all safety markings are legible. Do not discard the safety instructions; give them to the operator. The user shall
contact the manufacturer to obtain replacement marking labels when necessary.
Damaged or modified sanders can cause injury.
The use of any accessory with this tool not provided or specified by Sioux Tools can perform unpredictably.
Use only accessories provided or specified by Sioux Tools. Only qualified and trained operators should install, adjust or use the
sanders.
Tools that perform unpredictably can cause injury.
Operators and maintenance personnel shall be physically able to handle the bulk, mass and power of the tool.
Hold the tool correctly; be ready to counteract normal or sudden movements and have both hands available.Release the start-
and-stop device in the case of an interruption of the energy supply. Personal protective safety glasses shall be used; suitable
gloves and protective clothing are recommended. Inspect the backing pad before each use. Do not use if cracked or broken or
if it has been dropped. Never run the tool unless abrasive is applied to the workpiece. There is a risk of electrostatic discharge if
used on plastic and other non-conductive materials.
Potentially explosive atmospheres can cause by dust and fumes resulting from sanding. Always use dust extraction or suppression
systems which are suitable for the material being processed.
Be aware of workplace hazards.
Slips, trips and falls are major causes of workplace injury. Be aware of slippery surfaces caused by use of the tool and also
of trip hazards caused by the air line. Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if
damaged by use of the tool.
Workplace hazards can cause injury.
When disposing of a tool, do it in a way that does not harm personnel or the environment.
Form ZCE884 3 Date 2023October4/A