Werbung
Verfügbare Sprachen
Verfügbare Sprachen
07. Functional Description of the Equipment
The SAGOLA gun model 3300 GTO (Gravity, Pressure and Suction) can be used for applying
appropriately diluted products (paints, lacquers, varnishes, etc.), used widely in the automotive
industry, timber industry, plastics, etc.
In the gravity or suction version; the product to be applied is placed in the cup provided for this
purpose, from which it flows by gravity or suction to the fluid tip and is then mixed with spraying
air in a way that can be controlled from outside the air nozzle.
In the pressure version; the product to be applied is placed in the pressure tank (hereinafter
Reboiler) or using a pressure pump. From here it flows through a hose to the fluid tip and is them
mixed with spraying air in a way that can be controlled from outside the air nozzle.
When the trigger is pulled back to the first position, it engages the air valve stem, opening this
and allowing air to flow through.
When the trigger is pulled back fully, the product needle is retracted, allowing the product to flow
out. This is then sprayed in the form of a fan.
When the trigger is released, the needle returns to its initial position, first closing off the product
outlet and then the air valve and application stops.
08. Tips and Needles Kits and Air caps
SAGOLA supplies Nozzle Kits and Tip and Need-
le Kits of different sizes for a variety of different
applications. In order to replace these, proceed
as follows:
With the gun fully depressurised, remove the air nozzle. Remove the product regulator with
the spring and the spring stop and extract the needle to be replaced. Remove the tip with the
wrench supplied.
Fit the new tip and tighten. Now fit, in this order, the new needle, the spring and spring stop and
the product regulator. Lastly, fit the appropriate air nozzle.
There are Tip + needle Kits: Ø 1.00 / 1.20 / 1.30 / 1.40 / 1.60 / 1.80 / 2.00 / 2.20 / 2.80
Air Nozzle Kits GTO TECH, GTO HVLP, GTO EVO, 3300 EPA. 64S and 62S.
GTO
TECH
Air
consumption
285
L/min
Pressure
2
Bar
(*) PRESSURE FOR TEST CHECKER: With the HVLP nozzle You must not exceed the maximum
inlet pressure of 1.8 bar. An excess pressure will create an additional over spray and will re-
duce the transfer.
GTO
GTO
HVLP
EVO
360
255
2
1,8 (
)
*
ENGLISH
3300
64S
EPA
250
310
2
2
62S
270
2
Werbung
