Blaupunkt AHE801 Bedienungsanleitung Seite 9

AHE801
1. Water tank
1a. Maximum water level indicator
1b. Space for antibacterial cartridge
2. Tank lid with pump
3. Evaporator filter rack
4. Evaporator filter
5. Appliance body
6. Water filler lid
7. Aromatherapy cartridge drawer
8. Power supply unit and power socket
9. Control panel
9a. On/Off button
9b. MODE selector button
9c. Button AUTO - for setting the target
humidity in AUTO mode
9d. Button SPEED - fan speed setting
9e. TIMER button
PREPARING THE UNIT FOR OPERATION
1 Place the water tank on a flat level surface. You can pour water into the tank without exceeding the
maximum level.
2. Place the pump tank cover on the tank.
3. Place the filter rack in the recess of the lid. Pay attention to the embossing of the corners.
4. Place the body of the unit on top of the previously mentioned components.
5. Connect the power supply to the power socket on the unit and to an electrical outlet.
USING THE APPLIANCE
Fill up the water in the water tank. You can pour water into the tank directly or through the filling hole
under the water filler lid. Do not exceed the maximum level.
2. start the appliance using the on/off button. Set the desired operating mode using the Mode
selection button (9b) or the AUTO button (9c) or the SPEED button (9d).
- Pressing the AUTO button (9c) changes the expected humidity value. Each pressing raises the value
by 5%. The device will select the fan speed, which affects the effectiveness of the humidification,
according to the difference between the expected level and the humidity in the room.
- The SPEED button (9d) activates the fixed fan speed mode. Each press changes the speed between 1
and 6.
- The MODE button (9b) allows you to choose between strong, night, child modes. In strong mode the
unit will run at maximum speed (speed 6). In night mode, if the humidity is above 60%, the unit will run
at speed level 1, if the humidity is lower, at speed level 3. In child mode, when the humidity is above
55%, the unit will switch off the fan, when the humidity is between 50-55%, the speed level will be 1,
and when the humidity drops below 50%, the speed level will be 3.
- The mood light (backlight) can be switched on and off using the LIGHT button (9g).
- The keypad lock can be switched on or off by holding down the LIGHT (9g) button for a long time. This
function will be indicated by the icon on the display (9k).
- Air sterilisation with UVC light can be switched on and off using the UV button (9f ).
- Delayed shutdown can be set by pressing the TIMER button (9). Each press changes the time in which
the unit will be switched off.
To switch off the appliance, press the ON/OFF button (9a). This will start the filter drying mode, which
lasts half an hour. It is recommended if the appliance will not be used for a long time. Otherwise,
9f. UV button (air sterilization with UVC light)
9g. LIGHT button (LED backlight and button lock)
9h. Lack of water indicator
9i. Water level indicator
9j. Operating mode indicator (from left: strong,
night, child, filter drying)
9k. Keypad lock indicator
9l. HUMIDISTAT indicator (electronic automatic
control of the unit's operation depending on the
set level of expected humidity)
9m. UV lamp indicator
9n. LED backlight indicator
9o. Constant airflow indicator
9p. Fan speed level display
9r. Unit display (%, h - hour)
9s. WiFi indicator
5