Blaupunkt AHE801 Bedienungsanleitung Seite 10

AHE801
another press of the on/off button (9a) will switch the appliance off.
The amount of water in the tank is indicated on the display. When the water starts to run out, the
appliance will beep three times and the low water icon (9h) will flash. After 5 minutes of inactivity, the
icon will illuminate continuously.
After a period of inactivity, the display will go blank. Pressing any of the buttons will wake up the
display. To activate the function, press the button.
NOTE ON THE HUMIDIFYING EFFICIENCY OF THE APPLIANCE
The efficiency of water evaporation and air humidification largely depends on the relative humidity of
the air and indirectly on the ambient temperature. If the air humidity in the room is higher, the
humidification efficiency decreases. A humidifier used continuously in strong mode will strive to reach
100% humidity levels, but will never exceed them.
In the case of very high humidity, condensation may occur when the ambient temperature is lowered,
water will start to condense on surfaces.
The evaporation capacity at maximum fan speed is 1 litre of water per hour at 10% relative humidity at
25 degrees C. This drops to 0.8 litres per hour at 25% relative humidity, 0.6 litres at 40% humidity, 0.5
litres at 50% and 0.4 litres at 70% humidity.
CLEANING AND MAINTENANCE
1 Rinse the water tank regularly and wipe the inside of the tank and tank lid with a fine sponge.
Note: Do not submerge the appliance body and prevent water from entering the appliance body.
2 The filter should be rinsed regularly under running water, at least once a week. Do not use brushes or
other tools to clean the filter.
3) To remove deposits (scale) from the filter, it is recommended to leave the filter in a solution of
descaling solution or citric acid for some time (30-60 minutes). Then rinse the filter thoroughly under
running water.
The appliance contains an antibacterial cartridge. The minerals in this cartridge inhibit the growth of
bacteria and microorganisms in the water.
AROMATERAPY
To use the aromatherapy function and smell the room, apply a few drops of the fragrance preparation
to the sponge in the aromatherapy drawer (7). Remove the drawer, take off the drawer lid, drop a few
drops of the preparation on the sponge, close the drawer lid and slide it back in.
APP TO CONTROL THE APPLIANCE
In order to use the app to control the device, it is necessary to have a registered user account with the
"Tuya Smart" system. The app can be downloaded from the Google Play shop or the App Store. You can
also search for it using the QR link below:
After launching the Tuya Smart app, the user will be prompted to log in to the app or also to register a
user account with this system.
RESETTING THE DEVICE SETTINGS AND CREATING A NEW CONNECTION
To connect the device to the local WiFi network, reset the WiFi connection setting. Press the on/off
button (9a) longer. The WiFi LED will start flashing quickly, the device will be ready to search.
6