Ryobi CSD-4030G Bedienungsanleitung Seite 13

GB
F D
OPERATION
QUICK CHANGE CHUCK (Fig. 5)
A quick change chuck mounted on the screwdriver is
easy for inserting or remoring the bits. To insert a bit,
insert the bit into collet till lock. To remove a bit, simply
pull the sleeve of collet forward.
SPINDLE LOCK
The screwdriver spindle is locked when the On/Off switch
is not pressed.
This enables screws to be screwed in, even when the
battery is empty.
GRIP ZONE
Soft grip reduces the danger of slipping and thereby
improves the grip on the tool and handing.
At the same time, The rubber coating achieves a
vibration-reducing effect.
LED WORKLIGHT (Fig. 6)
The screwdriver has a built-in LED worklight. This feature
is convenient when working in close or tight areas where
additional light is needed. Whenever the switch trigger is
depressed, the LED worklight will illuminate.
NOTE: During normal operation, if the LED worklight will
not illuminate, charge the screwdriver.
MAINTENANCE
WARNING
When servicing, use only identical replacement
parts. Use of any other parts may create a
hazard or cause product damage.
E I P NL S DK N FIN GR
English
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
Do not open the battery yourself. There is a danger of
short circuit.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts
should be replaced at an Authorized Service Center.
ENVIRONMENTAL PROTECTION
9
H CZ RUS
WARNING
Always wear safety goggles or safety glasses
with side shields during product operation or
when blowing dust. If operation is dusty,
also wear a dust mask.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
Recycle raw materials instead of disposing
as waste. The machine, accessories and
packaging should
environmental-friendly recycling.
RO HR
PL SLO
be sorted
TR
for