Ryobi CSD-4030G Bedienungsanleitung Seite 12

GB
F D
SPECIFICATIONS
6. Grip zone
7. Charger
8. Red charge light
9. Input jack
10. Charger plug
11. To decrease torque
12. To increase torque
13. Torque adjustment ring
14. Reverse
15. Forward
16. Collet
17. Bit
OPERATION
WARNING
Do not allow familiarity with products to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating products.
Failure to do so could result in objects being
thrown into your eyes, resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
Driving screws with screwdriver bits
■
Light-duty drilling
■
TO CHARGE (Fig. 2)
When charging the screwdriver, a red charge light will
illuminate on the handle of the screwdriver. This red charge
light will go off when the screwdriver is fully charged.
Insert charger plug into input jack making sure it is
■
properly connect ed.
Charger can be used with normal household voltage
■
of 230 V, 50Hz, AC only.
Connect charger to power supply.
■
E I P NL S DK N FIN GR
English
After normal usage, a minimum of 3 hours of charging
■
time is required to fully recharge the screwdriver.
Do not place charger in an area of extreme heat or
■
cold. It will work best at normal room temperature.
Remove the product from the charger once it is fully
■
charged and ready for use.
ADJUSTABLE TORQUE CLUTCH
This screwdriver is equipped with an adjustable torque
clutch for driving different types of screws into different
ma te ri als. The proper setting depends on the type of
ma te ri al and the size of screw you are using.
ADJUSTING TORQUE (Fig. 3)
There are twelve torque indicator settings located on the
front of the screwdriver.
Rotate adjustment ring to desired setting, aligning
■
num ber on adjustment ring with arrow on housing.
1 - 2
3 - 4
5 - 7
8 - 9
10 - 11 For driving large screws
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK) (Fig. 4)
The direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With the
screwdriver held in normal operating position,
the direction of rotation selector should be positioned to
the left of the switch trigger for forward motion.
The direction is reversed when the selector is to the right
of the switch trigger.
Setting the switch trigger in the OFF (center lock) position
helps reduce the possibility of accidental starting when
not in use.
To stop the screwdriver, release the switch trigger and
allow the collet to come to a complete stop.
8
RO
H CZ RUS
WARNING
Battery products are always in operating
condition. Therefore, the switch should always be
locked when not in use or carrying at your side.
For driving small screws
For driving screws into soft material
For driving screws into soft and hard
materials
For driving screws into hard wood
For full power applications
HR
PL SLO TR