GreenWorks GD24CS30 Bedienungshandbuch Seite 11

Problem Possible cause
The machine
and battery are
not connected
correctly.
The battery level
is low.
The lock out but-
ton and the trig-
ger are not push-
ed at the same
time.
The battery is
too hot or too
cold.
The motor runs,
The machine is
but the chain
in the protection
does not cut cor-
mode to protect
rectly, or the mo-
the PCB.
tor stops after
around 3 sec-
onds.
The battery is
not charged.
The chain is not
lubricated.
Incorrect battery
storage tempera-
ture
8 TECHNICAL DATA
Voltage
No load speed
Guide bar length
Chain stop
Chain oil capacity
English
Solution
Make sure that
the battery re-
lease button
clicks when you
install the battery
pack.
Charge the bat-
tery pack.
1. Push the
lock-out but-
ton and hold
it.
2. Push the trig-
ger to start
the machine.
Refer to battery
and charger
manual.
Release the trig-
ger and start the
machine again.
Do not force the
machine to cut.
Charge the bat-
tery. Refer to the
battery and
charger manual
for correct charg-
ing procedures.
Lubricate the
chain to de-
crease the fric-
tion. Do not let
the guide bar
and the chain
operate without
sufficient lubri-
cant.
Cool the battery
pack until it de-
creases to the
ambient temper-
ature.
24 V DC
7.8 m/s
305 mm
< 2 s
180 ml
Weight (without battery
pack)
Measured sound pres-
sure level
Guaranteed sound power
level
Vibration
Chain
Guide bar
Battery model
Charger model
9 WARRANTY
(The full warranty terms and conditions can be found on
Greenworks website )
The Greenworks warranty is 3 years on the product,
and 2 years on batteries (consumer/private usage)
from the date of purchase. This warranty covers
manufacturing faults. A faulty product under warranty
might be either repaired or replaced. A unit that has
been misused or used in other ways then described
in the owner's manual might be rejected for warranty.
Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not
affected by any additional warranty offered by a dealer
or retailer.
A faulty product must be returned to the point of
purchase in order to claim for warranty, together with
the proof of purchase (receipt).
10 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name: Globe Technologies Europe GmbH
Address: Brunnenweg 17, 64331 Weiterstadt,
Germany
Name and address of the person authorised to compile
the technical file:
Name: Ralf Pankalla
Address: Brunnenweg 17, 64331 Weiter-
stadt, Germany
Herewith we declare that the product
9
2.6 kg
L = 92 dB(A), K = 3
pA pA
dB(A)
L = 106 dB(A)
wA.d
2 2
≤ 2.5 m/s , K = 1.5 m/s
90PX045X/
CL14345/90X-45E
124MLEA041/
M1431245-1041/
ES124MLEA041
G24B2/G24B4 and other
BAG series
G24C and other CAG ser-
ies
EN