List Of Parts; Harness Adjustment - Britton 3Way Gebrauchsanweisung

1 LIST OF PARTS

1 Head rest
2 Head cushion
3 Back rest
4 Chest pad (2x)

2 HARNESS ADJUSTMENT

The shoulder straps must be threaded through the slots in the cover and seat nearest the top
of the child shoulders. If in any doubt always use the slot above the shoulder rather than below
it. However, once you reach the top slots your child may continue to use the seat until their eye
line is above the top of the seat shell or their weight exceeds 18Kg.
To move the shoulder strap from one slot to another unclip the shoulder straps from the connec-
tor (a, b) at the back of the seat.
Feed the strap ends through the seat until they are clear of the cover (c).
Re-thread the shoulder strap back through your chosen shoulder slot in the seat (d). Make sure
it is not twisted. Repeat on the other shoulder strap.
Hook the shoulder straps back onto the connector (a,b).
Pull the adjustment strap forward to remove any slack (e).
3 APPROVED SEAT BELT REQUIREMENT
WARNING: Your child car seat can only be installed forward facing using a three point lap
and diagonal belt in the front or rear passenger seats of the car.
4 INSTALLATION OF THE CARSEAT 9-18 KG (APPROX 9MONTH-
4YEARS) GROUP 1
A Place the child car seat in the forward facing position on the car seat.
B Pull the vehicle seat belt and thread the diagonal belt through the fabric seat belt slot (a) and
the lap strap under the seat belt guide (b).
At the back of the seat feed the seat belt under the harness and through the other seat belt slot.
C Pass the seat belt under the other seat belt guide (d) then fasten the seat belt. Locate the
seat belt in the slot under the headrest (e).
D Carefully kneel on the child car seat to push it into the seat of the vehicle. Pull the seat belt (g)
to tighten the lap section of the belt.
E Pull the diagonal section of the seat belt tight at (g). The child car seat should now be secure.
5 SEATING YOUR CHILD INTO THE CAR SEAT HARNESS
A Loosen the harness by pushing the adjuster button (a) in as you pull the shoulder straps (b)
forward as much as possible.
Unfasten the harness buckle by pressing the red button (c) and releasing the shoulder straps (b).
Place your child in the seat.
B Fit the harness around your child and fasten the harness buckle by joining the shoulder straps
(b) and pushing them both into the buckle (c).
C Check that the harness is not twisted and pull the harness up (b) to tighten the lap sections
which is designed to fi t low down on your child's body.
5 Safety harness
6 Crotch pad
7 Lower seat liner
8 Booster seat
7
9 Adjustment stap
10 Head rest adjustment button
11 Shoulder pads connector
12 Harness connector
EN