Viatom Wellue BP2 Bedienungsanleitung Seite 16

To start an ECG Recording:
1. Put your right palm on the right side electrodes of the
monitor.
2. Place the left side electrodes to the body position that
you desired to measure.
3. Once the body parts are placed on the electrodes, press
the Function button to start EKG recording.
4. Wait for 30 seconds, the result readings will be displayed.
To start recording ECG again, press the Start/Stop button to
return to the Home screen, then press the Function button.
Note:
The recording must take at least 30 seconds to

complete, and to be analyzed by the detectors
You can get different signal amplitudes from different

methods. Use Lead II mode if the signal is too low in
Lead I mode.
3.3.3. Turn on/off Heartbeat Sound
The buzzer beeps when a heartbeat is detected while
recording ECG. You can turn on/off the heartbeat sound on
the App.
3.4 Reviewing History Records
You can review the history results and replay the recorded
ECG waveform on the History screen.
Hold the Function button for 2 seconds to enter the History
screen. The last measurement results will be displayed by
default
14