Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Scope of delivery
The scope of delivery includes:
•
New York
•
Remote control (incl. battery)
•
TMC Tuner (not for 1 011 203 821 / 1 011 303 831)
•
MicroSD card with navigation data in the MicroSD
card slot (only for devices with navigation)
•
GPS antenna
•
External Bluetooth microphone
•
Getting started
•
Support frame
•
Small parts set
•
Installation material
•
Connecting cable
Placing the device in operation
Caution!
Transport securing screws
Ensure that the transport securing screws are removed
before the startup of the device.
Theft protection
This car sound system is protected against theft with a
four-digit code number (code number is factory-set to
0000).
If the code query is activated, the code number must
be entered after every interruption of the power supply
from the vehicle battery.
Note:
In the General submenu of the settings menu, you
can activate/deactivate the code query and change
the code number.
Entering the code number after a voltage
interruption
If the code number is required, a keypad for entering the
code number is displayed.
u Enter the code number via the keypad.
u Press the [
] button to confi rm the entry.
The device is switched on.
Note:
If you entered an incorrect code number, the display
briefl y shows Security code incorrect!. Afterwards,
you can repeat the code entry.
Switching on/off
Switching on/off with the rotary/pushbutton
u For switch-on, press the rotary/pushbutton
u For switch-off , hold the rotary/pushbutton
pressed for more than 2 seconds.
Switching on/off via vehicle ignition
If the car sound system is connected with the vehicle
ignition and it was switched off with the rotary/pushbut-
5
ton
, it is switched on or off with the ignition.
Volume
Adjusting the volume
You can adjust the volume in steps from 0 (off ) to 50
(maximum).
u Turn the rotary/pushbutton
ume.
Muting the car sound system (Mute)
u Briefl y press the rotary/pushbutton
device or to reactivate the previous volume.
Main menu
In the main menu, you press the buttons on the touch-
screen to call up the diff erent sources and operating
modes.
u Press the MENU button
The main menu is displayed.
As long as you do not select a new audio source, the
last active audio source is played back.
Note:
The fi gures used in these instructions are intended
to facilitate the explanations and details may deviate
from your device.
Scope of delivery | Startup
5
.
5
to change the vol-
5
to mute the
2
.
5
27
Werbung
