Solo 582SM Gebrauchsanweisung Seite 29

Fig. 11
• Remove dipstick, hold horizontally and read oil
level. Oil level has to be between the "MAXIMUM"
and "MINIMUM" markings.
Changing Oil
The engine oil may be drained via the oil drain screw or
the oil filler opening. Blade and blower wheel need to
be removed to reach the oil drain screw (illustration 9).
Observe especially the service instructions in the
separate engine owners manual.
When draining via oil filler opening (14): Tilt the warm
mower (with fuel tank empty and closed oil filler ) slowly
over the side of the filler opening. Remove oil filler cap
and catch old oil in a container. Wait several minutes
until oil is drained. Dispose off the old oil in accordance
with local ordinances.
After changing oil, always wash hands with a scouring
agent, soap and water.
Attention: Never simply throw away used engine oil
and gear lubricant (environmental protection). Collect
used oil in authorized containers and submit to the
proper recycling facility.
10. Parts subject to wear and tear
Various parts are subject to application-specific wear or
to normal wear and must be replaced in good time if
necessary. The following parts are subject to normal
wear and are not covered by the manufacturers
guarantee:
• Blade and blade fixing
• Friction pads
• Air filter
• Spark plug
• Fluids, such as engine and gearbox oil
• Drive belts on lawnmowers with self-drive
• Place lawn mower
horizontally with all
wheels on the ground.
• Turn oil tank cap
counter-clock-wise (14),
and remove. Wipe off
dipstick.
• Place dipstick back into
filler pipe.
Maintenance and Care; Parts subject to wear and tear; Guarantee
The manufacturer guarantees problem free quality and
will cover the cost of replacing parts which are found to
be faulty in material or show manufacturing defects
within the prescribed guarantee period after the date of
purchase. Please note that specific guarantee
conditions may differ from country to country. When in
doubt, please ask the vendor of the goods. The vendor
of the product is responsible for guarantee applications.
We hope you will understand that we cannot be liable
for damage resulting from these causes:
• Non-compliance with operating instructions.
• Neglecting required maintenance and repair jobs.
• Damage caused by improper carburettor
adjustment.
• Wear from normal use.
• Obvious overload by continuously exceeding the
upper performance limit of the product.
• Using non-approved tools.
• Use of force, improper treatment, misuse and
accidents.
• Damage from excessive heat due to dirt build up
around the cooling fan housing.
• Attempted adjustments and repairs by non-
qualified persons.
• Use of unsuitable spare parts or non-original parts
if such parts are the cause of the damage.
• Use of unsuitable or stale fuel.
• Damage caused by using the product in the hire
or rental industry.
Normal cleaning, adjustments or maintenance jobs
cannot be claimed as part of the guarantee.
All guarantee work must be carried out by a service
centre authorized by the manufacturer.
In the best interest of continued technological progress
we reserve the right to change the design and
configuration of any product without prior notice.
For that reason, no claims can be accepted with
reference to text and illustrations in this manual.
11. Guarantee
ENGLISH 15