Solo 582SM Gebrauchsanweisung Seite 24

Preparing the equipment for use
6. Preparing the equipment for use
6.1 Assembly
Your lawnmower will be ready for use in only a few
steps.
Securing the handle:
The lower handle part is secured with handle pins (8)
and firmly held in place by the clamping block (18) in
the mower housing.
Fig. 2a
Connect the upper handle with the
Fig. 2b
lower handle and secure on both
sides with coach bolts 8x45 and
washers 8.4 mm dia.. Tighten with
star handles on the inside of the
handle.
Secure both bowden cables with
cable clips to the handle.
not damaged.
Placing starter handle in rope guide
Release the engine brake by pushing the brake lever
against the mower handle. Slowly pull the starter handle
and rest handle in rope guide on the upper handle (4).
Note: Take care when folding and unfolding the handles
to ensure that cables are not damaged in any way.
Folding of Handle
To fold the handle:
• disconnect starter rope from rope guide (4),
• loosen both clamping blocks with star handles and
pull out from mower housing,
• place lower handle to the rear of the mower,
• loosen handles (15) and
• fold upper handle towards the front.
ENGLISH 10
Loosen both star
handles M8 and
insert the clamping
block into the
mower housing until
flush. Tighten the
star handles.
Ensure the cables are free
of any sharp bends and are
6.2 Grass Catching Device
Install and remove catcher only with stopped
engine!
Fig. 3a
Pull the catcher over the frame and attach plastic
retaining flaps in the sequence 1-2-3-4 to the frame.
Fig. 3b
Fig. 4
To fit the catcher (6), lift the rear flap (7), rest the
catcher frame on the lower guide of the mower housing
(a) , lift catcher upwards (b) until the catcher completely
locks in the discharge flap (c).
Squeeze the upper
frame of the catcher
to allow the carrying
bracket to be fitted.